4
MOUNTING GUIDE
1 Mounting the transceivers
It’s very important that the transceivers
are mounted correctly:
E
Since the infrared laser beam from
the speed laser gun and the infra red
return signal from the transceivers will
not pass through any objects, it is
essential that the transceivers have an
unobstructed view of the road ahead.
E
The transceivers must point straight
ahead and not follow the curve on the
front of the car and must be horizon-
tal to the road surface and parallel to
the driving direction.
1.1 Determine the best location for the
two laser transceivers. For optimum
performance, install each transceiver
on either side of the front license
plate with a distance between the
two of 50 – 60 cm. Please see the
photo.
1.2 Fit the mounting brackets on each
transceiver using the screws.
1.3 Mount the transceivers making sure
that each transceiver is level to the
road and parallel to the driving direc
tion.
1.4 Use the enclosed spirit level to
adjust the horizontal angle for the two
transceivers. On the outer side of the
front on each transceiver you find a
detachable plug. Remove one plug on
each transceiver, and put the spirit
level into the cylindrical hole. Now you
can carefully adjust the angle of the
transceivers to horizontal position.
After finishing the adjustment, re-mount
the two plugs into the front of each
transceiver.
2 Interface Box
Locate a suitable place for the interface
box inside the car’s interior. The interface
box must not be located in the engine
compartment because of moisture. The
two cables from the transceivers are
plugged into two of the jacks indicated by
the numbers 1 to 4.
SPIRIT LEVEL
LEVEL TO THE ROAD
