Command Stand™ V2
© Blichmann Engineering, LLC 2021
For replacement parts, visit: blichmannengineering.com
5
Install the grommet on the RipTide™ power cable and extension cord (not included) as shown in
Figure 1
. Install the other
grommet on the end of the RipTide™ power cord and on your BrewCommander™ 120V power cord as shown in
Figure 2
. Install
the back plate to the body with the black #6 screws on the top as shown in
Figure 3
. Install the grommet into the back plate as
shown in
Figure 4
. Install the black #6 screws to the bottom of the back plate and install the grommet as shown in
Figure 5
.
Installation Tips:
• Rolling grommet over plug ends makes installation easier
• Store excess pump cord inside Command Stand™ channel
• Install grommets to the back plate after fastening the back
plate to the body.
Cable Management
Figure 1
Figure 2
Figure 5
Figure 3
Figure 4
