Remote Control
1.
2.
3.
4.
5.
6.
Recycling and Disposal
Do not dispose of your old unit in the
household trash!
Use the return and collection systems
available to dispose of the old device.
This manual may be updated from time to time without
any notice.
Set the GAIN to 200mV (Min), PHASE to NORM., LOW
PASS FILTER to Center before turning on the device.
Set the Bass/Treble of head unit to zero. Set volume
to lower level.
Gradually increase GAIN until the desired sound
effect is achieved or until the sound distribution in
the vehicle is even.
Avoid setting volume of the head unit and GAIN too
high to prevent sound distortion. Ensure speakers
are functioning well to avoid sound distortion too.
Then adjust the LOW PASS FILTER (L.P.F.) to the
desired frequency.
Changing the LPF will change the sound output of
the subwoofer. Continue to adjust GAIN, LPF and
volume until the desiredsetting is found.
Play the music from the head unit while sitting at the
driver and switch between NORM and REV to select
the desired sound output setting. The ideal PHASE
is subjective and varies from one vehicle to another,
depending on the location of the device and the
acoustic characteristics of the vehicle interior.
INTRODUCTION
1
Proper system planning is vital in order to maximize the
device’s performance and road safety. Plan your instal-
lation carefully to avoid compromising performance re-
liability of the system. Consult an authorized Blaupunkt
dealer for installation or reparation. Read the manual
carefully before operating the device for the first time.
Safety Notes
Ensure to follow below safety notes during installation
and wiring connection : -
•
•
•
Installation and Connection Instructions
•
•
•
Intergrated Fuse
•
Switching On/Off
•
Disclaimer
•
•
Disconnect the negative terminal of the battery.
Refer to the safety notes of vehicle manufacturer.
Ensure positions of the holes are nowhere near the
vehicle component to avoid any damage during
drilling.
Incorrect installation may result in malfunc-
tion of the device or the car sound system.
Select a dry and well-ventilated location to
install the device.
The device must not be installed on the rear
shelf, rear seats or exposed locations.
The installation location must be suitable for
screw holes and have stable ground support.
The integrated fuse in the device protects
the output voltage and the entire electrical
system in case of malfunction. Do not replace
damaged fuse with higher current.
This device will automatically turn on if audio
signal is detected. The device will also auto-
matically turn off if audio signal is received.
In no event shall Blaupunkt be liable for any
direct, indirect, punitive, incidental, special
consequential damages, to property or life,
improper storage, whatsoever arising out of
or connected with the use or misuse of our
products.
USA & CANADA : Product not intended for
sale in the United States and Canada. If
purchased in the U.S. or Canada, this product
is purchased as-is. No warranty, express or
implied is provided in the U.S. and Canada.
