B
LAUPUNKT
S
PECIFICATIONS
- VA1400, 1 C
HANNEL
A
MPLIFIER
– 1 –
All power ratings conform to CEA-2006 standards.
PARAMETER/FEATURE
VA1400
Channels 1
Size ( L x W x D)
without trim panels
15.1x9.1x2.4 inches (382x231x60mm)
Weight
14.5 lbs. (6.6 kg)
Spade screw speaker terminals?
YES
Maximum terminal wire size
10 ga.
Subsonic filter
YES (10 Hz)
Separate front/rear or left/right gains?
N/A
Fuse Type
ATC spade -Two 40A
Speaker short, short to +12V, and short to ground protection?
YES
High, low, and reverse voltage protection?
YES
Power output transistors
Low QZ MOSFET
Power supply transistors
MOSFET
Minimum speaker impedance
(non-bridged)
2 ohms
(bridged)
N/A
PERFORMANCE DATA
Rated power output @ 0.1% THD, 14.4V (CEA-2006)
1 channel into 4 ohms
(watts rms)
1 x 100 W
1 channel into 2 ohms
(watts rms)
1 x 600 W
Max Dynamic Power (watts rms)
700W
Total Harmonic Distortion @ full power
0.3% THD
Signal/Noise ratio (gain controls in center)
Measured @ 1 watt / 1 kHz
dBA
>80
Measured @ full rated power (0.1% THD) dBA
>100
Damping factor
>100
Frequency response (full-range mode)
50 - 250 Hz
High-pass crossover frequency limits
N/A
Low-pass crossover frequency limits
50 H z - 250 Hz (variable), 12dB/oct
Input impedance
10 kohms
Input signal voltage control range
0.3 - 8.0 vrms
Current Draw @ 13.8 VDC (typical values @ X watts / Efficiency %)
@ full rated power, unbridged
(@ 4 ohms)
50 A (50%)
@ 33% rated power, unbridged
(@ 4 ohms)
30 A (35%)
@ idle
(@ 4 ohms)
1 A
Minimum battery voltage to maintain rated power
12.6 VDC
Usable battery voltage
10 - 16 VDC
Trigger line voltage range
10 - 16 VDC
Trigger line current draw
< 20 mA
Turn on delay time
@ 2.0 seconds
Thermal shutoff temperature (average heat-sink temp)
@ 85˚ C (185˚ F)
This information is subject to change without notice!
www.midwestelectronics.com
