Remove the valve cap.
Screw in the nut.
Screw on the sensor.
Tighten up the nut to the sensor by using
the spanner.
Spray soap water on the nozzle to check
for leakage problem.
Clean the area before using it.
1.
2.
3.
4.
5.
6.
SENSOR INSTALLATION
5
Problems
Air leakage after sensor installation
No tire data are displayed after
completing installation
Missing or lost sensor
Sensor battery low
Change of tire location
Solutions
The tire valves may not be universal standard, please check with the local
workshop.
Ensure ACC is turned on.
Please purchase new sensor.
Please replace with battery CR1632.
Please reprogram the corresponding sensors.
If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt
authorized dealer if problem persist.
TROUBLESHOOTING
RECEIVER INSTALLATION WIRING DIAGRAM
Car Reverse Video
Output
Head Unit
Reverse Camera Signal
Input
Reverse Camera
Connect with the yellow (third wire)
Black
Yellow
Blue
Red
Connect to Ground Wire
Connect to Red Wire (Beside the Reverse Camera RCA Jack)
Connect to Headunit’s Reverse Trigger Wire DC 12V
Connect to ACC 12V Power Supply
4
Fix the wires hardness
by using cable tie
Connect wire harness and
the receiver, then cover it
with the cover board
After installation
