INSTALLATION
Recommendations
l
Carefully choose the mounting location so that the unit won’t interfere with normal driving.
l
mounting locations where the unit would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or
where it would subject to dust, dirt or excessive
vibration.
l
The illustration below shows a typical installation, however, you may need to adjust the installation, depending on the unit. If you have questions or need additional installation
hardware, consult your
dealer.
l
Make sure the unit is firmly anchored (preferably at both front and back)
and does not vibrate.
Mounting The Unit In Most Dashboards
Install the Sleeve in the dashboard.
2
3
Select and bend the appropriate tabs to hold the sleeve firmly in place.
A.
B.
Attach the Mounting Strap to the underside of the dashboard, using screw.
Anach the back of the unit to the mounting strap using the support stem bolt and hardware,
Bend these tabs
Mounting the Unit in a Japanese Car
I
I
You
may have
this unit in some Japanese cars
In
case, consult your Blaupunkt dealer.
Removing the Unit
Use the Release Keys as shown below. Keep them in a safe place in case you need them
me
MAINTENANCE
Fuse Replacement
When
the fuse, be sure to use one with the correct amperage.
will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one
for
as
could cause
and
damage to the
SPECIFICATIONS
Audio Power
Power Output end Total Harmonic Distortion: 10 watts per channel
continuous average output into 4 ohms, 4 channels driven, from
Hz with no more than 1%
total
Tuner
FM
Tuning Range:
87.5 108.0 MHz
Audio
07.5
107.9
MHz
Speaker Impedance:
10.7 MHz
Maximum Amp Power:
18
RMS Power:
ohms
Frequency:
FM Mono
Selectivity:
Signal-to-Noise Ratio:
Harmonic distortion at 1
Separation:
Frequency Response:
AM
Tuning Range:
531-l ,602
530-1.710
Seek lo
Seek
55
Frequency:
35
450
45
and
subject to change
75
at 400
65
(stereo), 70
(mono)
0.7% (stereo), 0.5% (mono)
30
30-l 5,000 Hz 3
Bass Control:
Treble Control:
Cassette
Signal-to-Noise Ratio:
Tape Wow and Flutter:
Tape Frequency Response:
General
Dimensions
projecting parts/controls):
Mass.
Power Requirement (neg.
Operating Temperature:
Accessones:
30 Watts 4 (at 4 ohms)
53
0.10%
50-15.000 Hz 3
170 50 153.5 mm
7 2 6 in.
Approx. 1.4 kg (3.0 lb.)
12 V DC car battery
15°F to
-10°C to 50°C
l
Unit
l
Faceplate
l
Mounting Hardware
. DIN Sleeve
l
Owner’s Manual in English, French, Spanish and Portuguese
