Rhodos CC 25 gb
18
Traffic Messages (ARI)
Many FM stations broadcast the current traf-
fic messages for their coverage area at regu-
lar intervals.
Together with the programme, the traffic sta-
tions transmit an “ARI signal”, which lets your
car radio detect the actual traffic station.
The traffic stations indicate the beginning
and the end of the message by an additional
signal. Traffic messages are “put through”
with a preset volume, the level of which can
be programmed (see chapter “Automatic Start
of the Station Seek Operation”). The set
automatically interrupts tape playback and
resumes play as soon as the message is
over.
Switching Traffic Messages
(ARI) On and Off
For switching ARI on and off
•
Press the ARI button
@
.
If the traffic station is on, “ARI” lights
up on the display
:
.
You can only capture traffic stations which
transmit an ARI signal.
Activating a Stored Station
If required, the memorized stations can be
activated at a keystroke.
•
Choose the storage level.
For this, press FM•T
A
until display
=
shows I, II or III, or T.
•
Briefly press the corresponding preset
button
B
.
Briefly Sampling a Station
(Radio Scan)
Starting with the currently tuned in station,
you can have the following ones briefly sam-
pled for approx. eight seconds each.
•
Briefly press the Scan knob
1
.
If the following station is found, it is
reproduced for approximately eight
seconds.The station’s frequency starts
blinking on display
8
; if it has already
been memorized, the corresponding
preset button starts blinking on display
9
. In addition, the storage level indi-
cator lights up on display
=
. Subse-
quently, the set starts searching for the
next station.
For selecting a sampled station:
•
Press the Scan knob
1
once again.
The Scan function is off.
After the search operation has been conclu-
ded, and no station has been chosen, the
radio starts playing the station from which
Station Scan was started before.
Sampling Memorized Stations
All memorized stations of a waveband can be
briefly sampled.
•
Press the PS rocker switch
4
.
One after another, the car radio will
then start introducing all memorized
stations of the selected waveband.
The set either samples the stations of
storage levels I-III or of the Travelstore
level “T”. This depends on the current
switching status.
If a preset button has no station alloca-
ted, this button is skipped.
To terminate this function:
•
Press the PS rocker switch
4
once
again.
The station currently sampled is
maintained.