Montreal RCM 45
24
•
Release preset buttons 1 and 4.
Now the security coding system is active.
The display will briefly show “CODE” each
time the set is turned on.
Re-start following an interrup-
tion of the power supply
(coding system is activated)
•
Turn on the radio.
The display shows “CODE”.
•
Briefly press preset button 1; the dis-
play shows “0000”.
•
Enter the code number given in the
Blaupunkt car radio passport:
Example: The code number is 2521.
- Press preset button 1 twice; the dis-
play shows “2000”.
- Press preset button 2 five times; the
display shows “2500”.
- Press preset button 3 twice; the dis-
play shows “2520”.
- Press preset button 4 once; the dis-
play shows “2521”.
•
To confirm the code number:
Press the upper part of the rocker
switch .
If you have entered the correct code, the unit
will now be ready for use.
If the display shows “CODE ERR”, you have
entered a wrong code. Re-enter the correct
code after the waiting time (“CODE” will ap-
pear in the display).
If you switch off the set while it is blocked, the
waiting time will start anew as soon as the
radio is turned on again.
Switching off security coding
•
Turn off the radio.
•
Press preset buttons 1 and 4 simulta-
neously and hold down while switching
the set on again.
The display shows “CODE”.
•
Now enter the code number to be found
in the car radio passport and confirm
(see example under “Re-start ...”).
Security coding is now switched off.
Optical indication for extra
security
To indicate that your unit is equipped with
security coding, you may let an LED installed
in the non-detachable part of the front panel
flash for extra security when the car is statio-
nary.
For this, the following requirements must be
fulfilled:
Permanent 12 V supply and the + ignition
lead must be connected correctly (as illustra-
ted in the installations instructions).
„LED 1“ must be adjusted in the DSC mode.
Read “DSC programming - CODE-LED”.
