PLACING THE DEVICE IN OPERATION
6
E
N
G
L
I
S
H
PLACING THE DEVICE IN
OPERATION
ATTENTION
TRANSPORT SECURING SCREWS
Before the startup of the car sound system,
ensure that the transport securing screws
have been removed (see the chapter
"Installation instructions").
ATTACHING/DETACHING THE
CONTROL PANEL
The car sound system is equipped with a
detachable control panel (release panel) to
protect your equipment against theft. In the
delivery state, the control panel is in the
supplied case. To start operating the radio
after installation, you must first attach the
control panel (see the section "Attaching
the control panel" in this chapter).
Always take the control panel with you
when leaving the vehicle. The car sound
system is worthless to a thief without this
control panel.
CAUTION
DAMAGE TO THE CONTROL PANEL
Never drop the control panel.
Transport the control panel so that it is
protected against impacts and the contacts
cannot become dirty.
Do not expose the control panel to direct
sunlight or another heat source.
Avoid direct skin contact with the control
panel's electrical contacts.
• ATTACHING THE CONTROL PANEL
Push the control panel into the bracket
at the right edge of the device.
Push the control panel carefully into the
left bracket until it clicks into place.
• Removing the control panel
Press the button
(24)
to unlock the
control panel.
The left side of the control panel
detaches from the device and is
secured by the bracket against falling
out.
Move the control panel slightly to the left
until it disengages from the right
bracket.
Carefully remove the control panel from
the left bracket.
Note:
The car sound system automatically
switches off as soon as the control
panel is removed.
