Blaupunkt FREIBURG DJ, Руководство по эксплуатации

Страница: 20 / 23

40
DSC programming
LOUDNESS Loudness boosts the bass
frequencies at low volume.
LOUD 1 - Low boost
LOUD 6 - Max. boost
TA VOL The traffic announcement
and warning beep volume
can be set between 0 to 66.
The message will then come
through at this volume, if the
standard volume is lower.
If the standard volume is set
higher than the TA VOL lev-
el, then the traffic report will
be played at the standard
volume.
REG Regional function on/off.
SENS DX1 To adjust the seek tuning
sensitivity.
“LO” stands for local recep-
tion.
“DX” stands for distant re-
ception.
Select “LO 3” if you want to
receive strong stations in
the local area, select “DX 1”
if you want to tune into
weaker stations which are
further away.
CLOCK 24 To switch between 12-h and
24-h clock display.
CLOCKSET To set the clock manually.
Press << >> to select hours/
minutes. Press / to adjust
the flashing value.
ON VOL To set the turn-on volume.
Press << >> to adjust the
turn-on volume as desired.
MUTE To change the mute volume.
BEEP X To change the volume of the
acknowledgement tone
(beep) between 0 and 9.
(0 = off)
RM OFF Radio Monitor
If the Radio Monitor function
is active during fast winding
of the tape, the set will
switch to the radio and play
the station previously re-
ceived.
The car radio has been equipped with DSC
(Direct Software Control) to allow you to
customise certain programmable, basic set-
tings to suit your personal needs and pref-
erences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always reset
to them if desired.
If you wish to alter any of the programming,
•
press DSC.
“MENU / ” will light up in the display.
Use the / buttons of the rocker switch to
select the function you wish to change. The
display will show you the setting you have
selected. Press the << >> buttons of the
rocker switch to change the values. Confirm
the setting you have selected by pressing
the DSC button.
/ Select function
<< >> Adjust/recall value