Blaupunkt FHD501, Руководство пользователя

Страница: 9 / 88

7
1. Display
2. Control Panel
a) Power Button
b) Mode Switch
c) Timer Button
d) Eco Button
e) Oscillation Button
f) “–” Button
g) “+” Button
3. Main Switch
4. Base
OPERATION
Preparing the device for operation: ensure that the Main Switch is set to OFF; connect the device to a
power supply; switch the device ON using the Main Switch. The device emits an acoustic signal. The
stand-by indicator lights up; the device enters stand-by mode.
Press the Power Button to switch on the Fan Heater. The Fan Heater will start operating in the most-
recently used mode.
Press the Mode Button to change the mode of operation:
1. Freezing Protection : the Fan Heater will keep the temperature in the room above 7°C to prevent
freezing.
2. Fan : the Fan Heater will operate as a fan only.
3. Warm Air
4. Hot Air
5. Very-Hot Air
The Fan Heater attempts to maintain the desired temperature by turning the heat on and off.
The desired temperature can be set by pressing “+” and “–”.
To switch off blowing or heating, press the Power Button . The Fan Heater goes into sleep mode after
counting down from 30.
To completely switch off the device, set the Main Switch to OFF and remove the plug from the socket.
Oscillation: to activate the oscillation function, press the Oscillation Button .
ECO: the heating power will be adjusted to the ambient temperature and the desired temperature. The
device sets its heat intensity based on the difference between the ambient temperature and the
desired temperature. The device automatically changes its heating mode during operation to reduce
power consumption and provide optimum comfort. Press the Eco Button to activate the Eco mode.
Press the button again to deactivate the Eco mode.
Timer:
The unit can be preset with the delay switch and on and off timer.
To program a delayed start, press the Timer Button when the device is in the sleep mode. Set the
time by pressing “+” and “–”: 0.5 hr. (30 minutes), 1 hr., 3 hrs., ..., 24 hrs. The selected time is stored after
2 seconds.
Press the Timer Button while the Thermal Fan is in operation to program the device to shut down
and enter the sleep mode. Set the timer by pressing “+” and “–”: 0.5 hr. (30 minutes), 1 hr., 3 hrs., ..., 24
hrs. The selected time is stored after 2 seconds.
The preset time can be adjusted by pressing the Timer Button and “+” and “–” or switched off
completely by pressing the Timer Button twice.
CLEANING AND MAINTENANCE
Before cleaning the heater make sure that it has been switched off, unplugged from the power socket.
Make sure the device has cooled down sufficiently.
Air inlets and outlets should be free of dust. Clean with dump cloth and wipe dry.
FHD501