Troubleshooting Guide
The following check will assist in the correction of most problems that you might encounter with your
unit. Perform the checks described below before contacting your Blaupunkt dealer.
Symptom
Cause
Remedy
No Power
Fuse blown.
Replace with a fuse of the same type
and rating as the original.
If the fuse blows again, consult with
your dealer.
Improper connection.
Check connections.
No Sound
Improper connection.
Check connections.
No Sound,
Fader set to non-existent speakers.
Two-Speak System
Set fader to center position to
determine if speakers are wired for
front or rear setting.
Magazine cannot be
Attempt made to insert magazine
installed.
improperly.
Insert it in proper direction.
Selected disc does
Disc is loaded incorrectly.
not play.
Load disc with play side facing up.
(Printed side should face down).
Large scratches on disc or warped
Compare sound with another disc. If
disc.
sound from second disc is
Noise is heard
acceptable, first disc is defective.
during playback or
Extemely dirty disc.
Clean disc.
sound is
intermittent.
Transit Screws still in place.
Remove 3 screws on bottom of unit
and try again.
Anti-Vibration Switch set in wrong
position.
Set the Anti-Vibration Switch to the
correct position (See page 7-l 1).
Wireless Remote
Control does not
work
Battery is dead.
Commander ir sensor or Wireless
Remote Control is dirty.
Replace Battery.
Clean the sensor and/or the control’s
lens.
Fuse Replacement
When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the
fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as
this could cause malfunction and serious damage to the unit.
Moisture Condensation
On a rainy day or in a very damp area, moisture may condense on the lens inside the unit Should this
occur, the unit will not operate properly. In this case, remove the disc and wait for about an hour until the
moisture has evaporated.
17
