SPECIFICATION
TROUBLESHOOTING
OPERATION INSTRUCTION
Indicator Display : PM 2.5 Level, Filter Replacement Reminder, Auto/ Manual Fan Speed
Pre-packed with Blaupunkt AirPure Filter (APF2)
Noise Level : 55dB
Fan Type : Centrifugal Fan
HEPA Filter Grade : H13
Applicable for Space : 5m3 - 10m3
Input Voltage : 5V
Current : 1A
Power : <7W
Dimensions : 200 x 150 x 55mm
Net Weight : 500g
Accessories : 4m USB Power Cable, Car Charger, Car Headrest Holder, Anti Slip Mat
•
•
•
•
•
•
•
•
•
•
•
•
3
4
Problems
Air purifier does
not power on
Airflow is
significantly
reduced
Unusual noise
while operating
Possible Causes
Air purifier is not connected to a power
supply.
Exceed filter replacement cycle.
Filter is not fitted properly.
Solutions
Ensure the USB cable is properly connected to
USB power supply ports and air purifier’s power
input.
Replace with new filter.
Refer to operation instruction for correct filter
replacement steps.
If any of the following problem occur, please resort to Troubleshooting for the possible
solutions. Consult Blaupunkt authorized dealer if problem persist.
Air Purifier
1.
2.
3.
Connect USB charger to the 5V/1A power supply input of Air Purifier. Air purifier will have buzzing sound and blue
illumination when turn on.
Power Button
a) Turn On/Off
• Press to manually turn on Air Purifier, press again to manually turn off.
b) After Filter Replacement
• Press and hold for 5 seconds on the power button to reset filter replacement reminder.
MODE Button
• The fan speed of air purifier can be adjusted by pressing “MODE” button (Auto/L/H).
*
Auto :
Smart fan will adjust fan speed according to air quality
*
L :
Low fan speed
*
H :
High fan speed
Connect to a USB port
