8
www.blaubergventilatoren.de
KOMFORT EC S/SB(-E) S11
THE UNIT MUST BE MOUNTED BY A QUALIFIED EXPERT ONLY, PROPERLY TRAINED AND HAVING
THE REQUIRED TOOLS AND MATERIALS.
FS1 HUMIDITY SENSOR MOUNTING AND CONNECTION
The FS1 humidity sensor is not included in the scope of delivery and should be ordered separately. The humidity sensor must be installed prior to unit
mounting.
Install the humidity sensor through the extract spigot into the mount located in the extract section of the casing. Then connect the humidity sensor
contact socket to the respective contact socket on the control unit, refer the wiring diagram.
Exhaust
air duct
Contact socket
for connection
to the control unit
Humidity sensor FS1
Humidity
sensor
contact socket
Fastener
EVH HEATER MOUNTING AND CONNECTION
The EVH pre-heater is not included in the delivery and is available on a separate order.
The heater is rated for connection to single-phase AC 230 V/50 (60) Hz.
The heater is designed for mounting in the air duct connected with the intake spigot of the
unit.
The heater and the air handling unit must be connected via the cable with the DB-9M
connectors through the DB-9F connectors on the unit and on the heater.
SERVICE SIDE CHANGE
Make sure of the correct unit service side selection. Unit mounting position should enable free excess to the service panel for maintenance and service
operations.
INTAKE AIR
SUPPLY AIR
EXTRACT AIR
EXHAUST AIR
Left-handed modification
INTAKE AIR
EXHAUST AIR
SUPPLY AIR
EXTRACT AIR
Right-handed modification
MOUNTING AND SET-UP