BLAUBERG CDT E1, Руководство по эксплуатации, Страница: 7 / 20

7
CONNECTION TO
POWER MAINS
To connect the speed controller to the power mains follow the wiring connection diagram,
Fig. 6.
Connection sequence:
- Remove the decorative front panel and the base, Fig. A and B;
- Route the wires through the ports 2, 6 in the controller casing;
- Strip the wire ends 7–8 mm long;
- Connect the wires to terminal blocks 8 and 9 (Fig. 2) according to the wiring connection
diagram, Fig. 3;
- Secure the wires with clamps 1 and 5, Fig. 2;
- Re-install the base and the decorative front panel.
L
N
L N
В
L N 1 2
6
B - fan;
S - controller.
S
MINIMUM
SPEED SETTING
On the initial start set up the minimum speed of the connected fan.
To set the minimum rotation speed set the control knob 1, Fig. 4 on the front panel
to the leftmost position and then gently rotate the control knob of potentiometer 5,
Fig. 5 with the plastic screwdriver (included into the delivery) to the right or to the left
until the fan starts rotating steadily.
CDT(E) E