Blata Origami B1, Руководство по обслуживанию

Страница: 8 / 17

REMOVE AND REPLACE THE FRONT WHEEL - FIG. 5
Before dismantling the front wheel it is necessary to remove the front brake
pads from the front brake, so it is possible to move the brake caliper from the
wheel and be able to draw out the wheel and tire. Remove the front axel nut.
M10 (920.011.01) Draw out the axel from the fork and wheel. Remove the wheel
by an easy pull downwards from the forks. CAUTION! Two 3mm spacers will
fall out when the wheel is being removed! Insert one spacer between the brake
rotor and the brake mounting bracket, and the other spacer between the wheel
and the right fork (P/N 315.011.00) when re-assembling. Return the brake pads
with the spring and tighten up the axel nut. Perform the basic brake adjusting.
Double check your work. This is important!
REMOVE AND REPLACE THE REAR WHEEL - FIG. 5
Loosen and remove nut M10 on the rear axle. Safely (hold) keep the rear wheel
from falling out while pulling out the axel. Caution, note the location of both
spacer tubes and one spacer washer (between caliper mount plate and rotor)
while removing wheel. When refitting the wheel, make sure to slide the brake
rotor into the caliper between the pads. Hold the wheel in place and fit the
wheel spacers in proper order. . Insert one 3mm spacer between the brake
rotor and brake mounting bracket and than insert the 9.5mm spacer between
the brake and the rear swing arm. Adjust chain tension and tighten axel nut.
Tighten the caliper holder plate nut and set and tighten both chain adjustor
plate M6 nuts. At this time check the brake operation. Recheck all your work.
This is important!
REPLACEMENT OF PINION - FIG. 9
First dismantle the front chain guard and chain guard.Loosen the nut of rear
wheel axle and the nut of chain tightener ,remove chain. Insert carefully a
larger screw driver or steel rod into the hole of clutch drum, Fig. 9, to avoid a
turning over the clutch drum at releasing the pinion. Using the pinion wrench
P/ N 319.050.00, release the new pinion to be carried out by reverse way.
FIG. 9