Blastrac bg-250g11, Руководство пользователя, Страница: 39 / 72

Operating Instructions BG-250G11/G13
Initial Operation November 2004
© Copyright Blastrac 32 Revision (A) 12-23-04
Electric Start (G13)
See “Handgrip and Operating Lever” and make sure the diamond disc is off the
ground and the machine is secure before starting. Push the throttle control forward
all the way to engage the engine choke. Turn the key to start and hold to engage
the electric start. Do not hold for more than three seconds while attempting to start.
Holding on the start for long periods of time will damage the starter and drain the
battery. See Honda Operating Manual for details concerning the operation of the
Honda engine.
Emergency Stop switch
Pressing this switch immediately interrupts the power supply to all units of the
machine. This red button is also used as OFF switch on the G11.
Throttle Control
The throttle control may be pushed all the way forward to engage the choke and
pulled all the way back to stop the engine. Cable may stretch over time requiring
adjustment for correct operation. Push forward to increase engine speed and
pull back to decrease engine speed.
Stopping
The grinding machine must be
lifted by pushing down on the
handgrip (2) and pulling back
on the operating lever (1).
Pulling back on the operating
lever (1) will lower the jack
stand and take the weight off
the grinding disc. Pull throttle
(3) all the way back or push E-
stop (4). Key (5) on G13 may
be turned to OFF to stop
machine.
2
1
3
4
5
Figure 5.4