DRP 393 MPEG-4 Receiver/Decoder
Page 8 (36)
www.blankom-digital.de
Rev. L
Front view
LED
Marking
Colour Function
INPUT
Green
Red
Orange
Input signal available
Input signal missing
Invalid input signal
STATUS
Green
Red
Orange
Function OK
Function faulty (see LCD display)
Function critical (see LCD display)
FAULT
Red
Internal hardware fault
Control with display and navigation wheel
All configurations are made by turning and pressing the navigation wheel located at the front of the device
at the right side. By turning the wheel, one can navigate through the entire menu. The selected menu is
shown inversely. You can select the menu by simply pressing the navigation wheel.
If the navigation wheel is not operated for 30 minutes, the display illumination is automatically switched off.
If you start a new operation, the lights will be switched on once again!
Configuration mode (CFG)
For changing the configurations, the user must select “CFG” in the corresponding menu and keep the wheel
pressed for at least 3 sec. until a * appears behind “CFG”. Then, the user can select the corresponding
parameters with the wheel, which are presented with a blinking display.
You can now change the configuration with the navigation wheel. If a parameter is changed “SAVE” appears
in the display; by pressing the navigation wheel, this parameter can be selected for saving. “SAVE” is
displayed inversely; the configuration is saved in the device by simply pressing the wheel.
After 30 sec. the configuration mode is switched off automatically if the navigation wheel is not in use.
Operation display
If an input signal is connected the most important
information about the configured channel are
displayed. Example:
Navigation wheel
Status LEDs
DVB common interface
(top / bottom)
ASI test
output
Video test
output
Audio test
output
