Blanco RUL70X, Инструкции по использованию и уходу

Страница: 9 / 12

USE AND MAINTENANCE
• It is recommended to operate the appliance prior to cooking. It is recommended to leave the appliance in
operation for 15 minutes after cooking is terminated in order to help eliminate cooking vapors and odors. The
proper function of the rangehood is conditioned by the regularity of the maintenance operations, in particular,
the active carbon filter.
• The anti-grease filters capture the grease particles suspended in the air, and are therefore subject to clogging
according to the frequency of the use of the appliance. In order to prevent fire hazard, it is recommended to
clean the filter at a maximum of 2 months by carrying out the following instructions:
- Remove the anti-grease filters from the rangehood and wash them in a solution of water and neutral liquid
detergent, leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The anti-grease filters may also be washed in the dishwasher. The aluminum panels may alter in colour after
several washes. This is not cause for customer complaint nor replacement of panels.
• The active carbon filters help to purify the air that is replaced in the environment. The filters are not washable
nor reusable and must be replaced at maximum every four months. The saturation of the active carbon filter
depends on the frequency of use of the appliance, by the type of cooking and the regularity of cleaning the
anti-grease filters.
• Clean the fan and other surfaces of the rangehood regularly using a cloth moistened with denatured alcohol
or non abrasive liquid detergent.
• The light function is designed for use during cooking and not for prolonged general illumination of the
environment. Prolonged use will notably reduce the duration of the bulb.
• Replacing LED lamps ( Fig.8):
Replacement of the LED lamps needs to be carried out by an authorised technician. Please contact an authorised
service centre when this needs to be arranged.
• Commands (Fig.9) luminous the key symbols are explained below:
A
= LIGHT
B
= OFF
C = SPEED I
D
= SPEED II
E
= SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes
•
To operate the
INTENSIVE
speed function, press key
E
for two seconds and it will be activated for 10 minutes
after which it will return to the previously set speed. When the function is active the LED flashes. To interrupt it
before the 10 minutes have expired press key
E
again.
• By pressing key F for two seconds (with the rangehood switched off) the " clean air " function is activated.
This function switches the appliance on for ten minutes every hour at speed level 1. As soon as this function is
activated the motor starts up at speed level 1 for ten minutes, During this time key
F
and key
C
will flash at the
same time.
After ten minutes the motor switches off and the LED of key
F
remains switched on with a fixed light until the
motor starts up again at speed level 1 after fifty minutes. Keys
F
and
C
start to flash again for ten minutes and so on.
By pressing any key (excluding the rangehood light key A ) the " clean air " function will be deactivated and the
rangehood will return to normal operation (e.g. if key
D
is pressed the "
clean air
" function is deactivated and
the motor moves to the 2nd speed straight away. By pressing key
B
the function is deactivated).
(*) The "
AUTOMATIC STOP TIMER
" delays stopping of the rangehood, which will continue functioning for 15
minutes at the operating speed set at the time this function is activated.
• Active carbon/grease filter saturation:
- When button A flashes at a frequency of 2 seconds , the grease filters must be cleaned.
- When button A flashes at a frequency of 0.5 seconds , the carbon filters must be replaced.
After the filter has been replaced, the electronic memory must be reset by pressing button
A
for approximately
5 seconds , until the light on the button stops flashing.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY BREACHING
THE WARNINGS SET OUT IN THIS MANUAL.
- 9 -