Blanco BRST60X, Инструкции по использованию, уходу и установке, Страница: 6 / 11

- 6 -
GENERAL
Carefully read the following important information regarding installation safety and maintenance.
Keep this information booklet accessible for further consultations. The appliance has been designed
as a exhausting version (external exhaust) or as a filter version (internal air recycle) rangehood.
SAFETY PRECAUTION
1. Take care when the rangehood is operating simultaneously with an open fireplace or burner that
depend on the air in the environment and are supplied by other than electrical energy, as the cooker
hood removes the air from the environment which a burner or fireplace need for combustion. The
negative pressure in the environment must not exceed 4Pa (4x10 -5 bar). Provide adequate ventila-
tion in the environment for a safe operation of the rangehood. Follow the local laws applicable for
external air evacuation.
Before connecting the model to the electricity network:
-Inspect the data plate (positioned inside the appliance) to ascertain that the voltage and power
correspond to the network and the socket is suitable. If in doubt ask a qualified electrician.
General Warnings.
• The appliance is not intended for use by young children or infirm persons without supervision.
• Young children should be supervised to ensure that they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
• There shall be adequate ventilation of the room when the range hood is used at the same time as
appliances burning gas or other fuels.
• Ensure that the range hood is cleaned frequently.
• There is a risk of fire if cleaning is not carried out in accordance with the instructions.
• Do not flambé under the range hood.
Warnings for Installation:
• The exhaust air must not be discharged into a flue which is used for exhausting fumes from
appliances burning gas or other fuels.
• The minimum distance between the support surfaces of the cooking pots on the cooker top and the
lowest part of the rangehood must be at least 6
5 cm.
• The regulations concerning the discharge of exhaust air have to be fulfilled.
INSTALLATION INSTRUCTIONS
• Electric Connection
The appliance has been manufactured as a class II, therefore no earth cable is necessary. The
connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral If not provided,
connect a plug for the electrical load indicated on the description label. Where a plug is provided, the
rangehood must be installed in order that the plug is easily accessible. An omnipolar switch with a
minimum aperture of 3mm between contacts, in line with the electrical load and local standards, must
be placed between the appliance and the network in the case of direct connection to the electrical
network.
• If a connection tube composed of two parts is used, the upper part must be placed outside the lower
part. Do not connect the rangehood exhaust to the same conductor used to circulate hot air or for
evacuating fumes from other appliances generated by other than an electrical source.
• INSTALLATION.
The following instruction should be followed to carry out the correct installation of the cooker hood.
1)
Mounting of the rangehood on the lower side of the cupboard.
2) Selection of the version (extraction or filtration) Mounting the rangehood on the lower side of the
cupboard.
This appliance must be fitted to a cupboard or other suitable support. For fixing use 4 screws suitable
for the cupboard, using the hole in Fig.1. When mounting align the front of the rangehood to the door
of the cupboard and regulate the L wall spacer through the screws marked P (Fig. 2). The rear of the