Installation
Exercise care when a rangehood is installed in an area where a gas burner is operating. Depending
on the size of the room, the rangehood may draw from the room air that is necessary for proper
combustion of the burner. All Blanco rangehoods are used for indoor application only.
Rangehoods may be installed in two ways:
1. Ducted to the atmosphere (outside).
2. Recirculating.
We recommend ducting to the atmosphere to ensure optimum performance. Recirculating the air
back into the room should only be used when outside extraction is not possible. To ensure maximum
performance when ducting it is important the ducting that carries the fumes away, be as short and as
straight as possible.
When incorporating a rangehood in the design of a kitchen the following points need to be considered
to achieve the most benefit from the rangehood.
1. Ducting from a rangehood carrying the exhaust air, should not exceed a length of three (3) metres.
2. For ducted installation we recommend using galvanised or similar metal type flue pipe. PVC pipe is
not recommended.
3. Ducting containing a 90° degree bend will encounter a loss in efficiency of approximately 35%.
Additional 90° degree bends can cause losses of up to 15% per bend.
4. Ducting size should always comply with the manufacturers specification.
5. We recommend carbon filters be used when re-circulating the air into the room. There will be some
loss of air movement when carbon filters are fitted.
USE AND MAINTENANCE
•
It is recommended to operate the appliance prior to cooking. It is recommended to leave the
appliance in operation for 15 minutes after cooking is terminated in order to completely eliminate
cooking vapours and odours. The proper function of the rangehood is conditioned by the regularity
of the maintenance operations, in particular, the active carbon filter.
•
The aluminium filters capture the grease particles suspended in the air, and are therefore subject to
clogging according to the frequency of the use of the appliance.
In order to prevent fire hazard, it is recommendable to clean the aluminium filter at a maximum of 2
months by carrying out the following instructions:
-Remove the aluminium filters from the rangehood and wash them in a solution of water and neutral
liquid detergent, leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
-The filters may also be washed in the dishwasher. The aluminum panels may alter in colour after
several washes. This is not cause for customer complaint nor replacement of panels.
•
The active carbon filters purify the air that is replaced in the environment. The carbon filters are not
washable nor re-useable and must be replaced at maximum every four months. The saturation of the
active carbon filter depends on the frequency of use of the appliance, by the type of cooking and the
regularity of cleaning the aluminium filters.
•
Clean the fan and other surfaces of the rangehood regularly using a cloth moistened with a non
abrasive liquid detergent.
• The rangehood lighting is designed for use during cooking and not for prolonged general illumination
of the environment. Prolonged use of the lighting notably reduces the duration (life) of the bulb.
•
Halogen lamp bulb replacement: Use a small, flat screwdriver to remove the glass cover (Fig. 8).
Remove old bulb and replace with a new one with the same ratings (fig. 10) - take care not to touch
bulb with bare fingers. Replace cover.
The controls are shown on Fig. 9. Select position A1 on switch A to turn off halogen lamps and position
A2 to turn them on.
Switch B controls the fan speed. Select position B1 to turn fan off, B2 for low speed, B3 for medium
speed and B4 for maximum speed.
Light C will be lit when the appliance is in use.
Содержание BRS61X
Страница 1: ...Slide Out Rangehood Instructions for the Use and Care and Installation of BRS61X...
Страница 3: ...Fig 1 Fig 2 Fig 3...
Страница 4: ...5 g i F 4 g i F Fig 6 Fig 7 Fig 8 Fig 9 Fig 10...
Страница 8: ......
