21
24
Installation Instruction
Connecting the water inlet hose
(for cold water)
Connection the cold water supply hose to a
threaded 3/4
''
water tap
and make sure that
it is fastened tightly in place.
If the water hoses are new or have not
been used for an extended period of time, let
the water run
through
to make sure that the
water is clear and free of impurities,
If this precaution is not taken, there is
a risk that the water inlet can get
blocked and the appliance could
be damaged.
Electrical connection
Make sure the socket is compatible
with the plug of the appliance
.
The socket must have earthing wire, and
be
rated to
2
3
0
-240
V/10A,
otherwise damage to
the appliance may occur.
Do not run any other appliances from the
same power socket at the same time as the
dishwasher.
7
Drain hose hook
sink
M
a
x
:1
0
0
0
m
m
M
in
:4
0
0
m
m
outlet hose
Min:40mm
Connecting the water outlet hose
Put the hose into
a
drainage
pipe with a diameter of
more than
40mm or into the sink
waste pipe
,
. T
he
outlet pipe
must be
straight
,
and the height of the end
of pipe should be less than 1000mm
higher than the
base of the dishwasher
.
Notice: The outlet pipe
connector
should be tight.
8
Level Adjustment
Allowable slope under entire dishwasher is 2 degree. Adjust the height by
turning the feet to make sure the dishwasher is level.
Tension Adjustment of the Door Spring
After plac
ing
the panel on the dishwasher, open and close the door
to test the balance
of the door (see
whether the door can remain a
t
the
same place. If not,
turn
the
adjustment
screw to adjust the
balance of the door.
+
-
Adjust the back feet
Adjust the front feet
+
-
+
-
Fix the dishwasher to the cabinet using four ST4*26 self-
tapping wood screws. There are four holes on the inside edge
of the dishwasher. Open the door, place the screws in the
supplied hole plugs, and screw through into the cabinet.
1.Fixing the dishwasher with the cabinet by turning the screws.
2.Plug the four hole plugs into the holes in the sketch map.
Fixation of dishwasher
ST4*26
hole plug
Hexnut tools
CR-V 4mm
Notice:
The required height of the skirting board is
determined by the height
of the ornamental plate and clearance when the door is opened
.
Installation of skirting board
9
Referenced dimension
serial
number
1
2
3
4
5
6
ornamental
plate
708mm
698mm
688mm
678mm
668mm
658mm
skirting board
75mm
85mm
95mm
105mm
115mm
125mm
-
+
7
0
8
m
a
x
6
5
8
m
in
ornamental plate
1
2
5
m
a
x
7
5
m
in
skirting board
15
4
Fix the dishwasher to the cabinet using four ST4*26 self-
tapping wood screws. There are four holes on the inside edge
of the dishwasher. Open the door, place the screws in the
supplied hole plugs, and screw through into the cabinet.
1.Fixing the dishwasher with the cabinet by turning the screws.
2.Plug the four hole plugs into the holes in the sketch map.
Fixation of dishwasher
ST4*26
hole plug
9
That the purchaser contact Blanco prior to any product repair.
That the purchaser carefully follows all instructions provided with the product and complies with all relevant electrical & plumbing
regulations in their State when installing the product.
That the purchaser carefully follows the instructions provided in the owner’s handbook relating to the proper use and care of the
product and does not use the product for any purpose other than the DOMESTIC use for which it has been designed. If the
appliance is used in commercial applications or for rental purposes,
Our Warranty
is limited to a warranty of
Twelve (12)
months
covering all parts with
Three (3) months
on any labour cost of service or repair.
SERVICE AREA
The provision of service under
Our Warranty
is limited by the boundary / territory area of the nearest service centre. Travelling cost incurred
for service outside this area is not covered by Our Warranty and service will incur commercial cost to be paid by the customer regulated by
the number of kilometres travelled beyond the service area. These costs will be disclosed to you for acceptance by you prior to your claim
being processed.
Microwave ovens
must
be returned to your nearest Authorised Service Centre for repair as they are a carry in serviceable appliance.
WHAT IS COVERED: By Our Warranty
During the warranty period, Blanco or its authorised Service Centre will at no extra charge, if your appliance is readily accessible without the
need of special equipment and subject to the terms and conditions of this warranty, repair or replace any parts which it considers defective.
WHAT IS NOT COVERED: By Our Warranty
Products installed damaged or incomplete or not in compliance with the relevant electrical & plumbing regulations in their State.
Normal wear and tear e.g. cleaning, light globes, filters etc.
Failure resulting from power surges and electrical storms.
Insect or vermin infestation.
Unauthorised repairs or use of non genuine Blanco parts.
Any failure caused by the product not being used in accordance with the instruction and the installation manual provided with the product.
Misuse or abuse, including failure to properly maintain or service.
The clearing of blockages in pumps and hoses.
Damage which occurs during delivery or installation.
Claims to product surface coating due to liquid or solid spill-overs, accidental damage or damage caused from cleaning products not
recommended by Blanco.
HOW TO CLAIM OUR WARRANTY
You will need to contact Blanco in Australia or New Zealand by using the contact details below.
IN AUSTRALIA
Blanco is distributed by Shriro Australia Pty Ltd
Locked Bag 5002, Kingsgrove, NSW, 2208 Phone:
1300 795 572 Fax: 1800 686 413
Email:
Web:
http://www.blanco-australia.com/
IN NEW ZEALAND
Blanco is distributed by Monaco Corporation
(Member of Shriro Australia Pty Ltd)
PO Box 4399, Shortland St, Auckland, 1140
Phone: 09 415 6000 Fax: 09 415 7060
Email:
customercare
@
monacocorp.co.nz
Web: http://www.blanco
.co.nz
/
Note: Please complete the following details when you have unpacked the product and staple this card with the purchase
invoice or sales docket.
Model No<<<<<<<<<<<<<<<<
Serial No<<<<<<<<<<<<<<<
Date of Purchase<<<<<<<<<<<..<
Retailer<<<<<<<<<<<<<<<.<
AUSTRALIAN & NEW ZEALAND PRODUCT WARRANTY
STATEMENT OF STANDARD WARRANTY CONDITIONS
AUSTRALIAN CUSTOMERS
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund
for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
NEW ZEALAND CUSTOMERS
Nothing herein contained shall be construed in any way as excluding or limiting your rights under the Consumer Guarantee Act 1993.
OUR WARRANTY
This product is also covered by the manufacturer's warranty set out in this document (
Our Warranty
).
Our Warranty is for a period of
fourty
eight
(
48
)
months from the date of purchase and for dishwasher & refrigeration appliances will
have an additional
thirty six (36) months
after the first
twenty four (24) months
on the wash motor for dishwashers & on the Sealed
System (
PARTS
only
Compressor & condenser etc) for refrigeration appliances. The labour cost to replace these parts is the
responsibility of the customer.
This is in addition to (and does not exclude, restrict or modify) any rights or remedies to which you may already be entitled under the
Australian consumer Law or the New Zealand Consumer Guarantee Act 1993 relating to this product.
Our Warranty
(which is subject to the conditions below) covers rectification free of charge of any fault arising from defective materials or
components, or faulty workmanship. The product will be repaired or replaced at the option of Blanco, and all costs of installation, removal,
cartage, freight travelling expenses and insurance are to be paid by the customer.
Our Warranty
is subject to the following conditions:
