7
Installation
Electrical Connection
1.
Your oven requires a 16 Amp fuse and must be installation by a qualified electrician.
2.
Your oven is adjusted in compliance with 220-240V AC/380-415V AC 50/60Hz. electric
supply. If the mains are different from this specified value, contact your authorized service.
3.
Electrical connection of the oven should only be made by the sockets with earth system
installed in compliance with the regulations. If there is no proper socket with earth system in
the place where the oven will be placed, immediately contact a qualified electrician.
Manufacturer shall never be responsible from the damages that will arise because of the
sockets connected to the appliance with no earth system. If the ends of the electrical
connection cable are open, according to the appliance type, make a proper switch installed in
the mains by which all ends can be disconnected in case of connecting / disconnecting from /
to the mains.
4.
If your electrical supply cable gets damaged, it should be replaced by an authorized service
or qualified electricians immediately in order to avoid the danger.
5.
Electrical cable should not touch the hot parts of the appliance.
6.
Please operate your oven in a dry atmosphere.
Gas Connection
WARNING
: Before starting any work related with gas installation, turn off the gas supply.
Risk of
explosion
.
1.
Fit the clamp to the hose. Push on the hose until it goes to the end of the pipe.
2.
For the sealing control; ensure that the buttons in the control panel are closed, but the gas
cylinder is open. Apply some soap bubbles to the connection. If there is gas leakage, there
will be foaming in the soaped area.
3.
The oven should be used a well ventilation room and should be installed on flat ground.
4.
Re-inspect the gas connection.
5.
When placing your oven in its location, ensure that it is at the counter level. Bring it to the
counter level by adjusting the feet if necessary.
6.
Do not route the gas hose and electrical supply cable of your oven through heated areas,
especially through the rear side of the oven. Do not move the oven with the gas connected
as this can cause a gas leak.
7.
Please use a flexible hose for gas connection.
