Blanco BFD645X, Инструкция по эксплуатации

Страница: 18 / 23

for personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
FROM THE POWER CORD.
EARTHING
CONNECTION
Improper connection of the equipment earthing conductor can result in the risk of an
electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
A hose that attach es to a s ink spray can burst if it is insta lled on the same water li ne as the dishwasher. If your sink
has one, it is recommende d that the ho se b e disconnected and t he hole plugged.
Pull The safety supply hoses completely out from the storage compartment located at rear of
dishwasher.
Turn water fully on before starting the dishwasher.
1
Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
The safety supply hose consists of the double walls. The hose's system guarante es its intervention by blocking the
flow o f wa ter in case of the sup ply hose bre aking and when the air space between the sup ply hose itse lf and th e ou ter
corrugate d ho se is full of water.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
Unscrew the safety supply hose from the faucet.
3
2
1
2
3
The appliance must be connected to the water mains using new hose-sets.
The old hose-se ts should not be reused.
Water pressure must be betw een 0,04 MPa and 1 MPa. If the pressure is be low the
min imum co nsult our Service Dep artmen t for advice.
Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is fastened tig htly in place.
If the water pipes are new o r have not been used for an extended period of time , let the water run to make sure that the
water is clear and free of impurities. If this precaution is not ta ken, there is a risk that the water inlet can g et blocked
and dama ge the ap pliance.