Blanco BCCT63X, Инструкции по использованию, уходу и установке, Страница: 6 / 12

Important.
The installer must leave a minimum gap of 3mm between the hob frame and the bench cut-out
on the sides indicated in fi g1.
Electrical connections
L
3
L
2
L
1
220-240V 3~ H05V2V2-F 4G 2.5mm
2
N
L
1
L
2
L
3
380-415V 3N~ H05V2V2-F 5G 2.5mm
2
L
N
220-240V 1N ~ H05V2V2-F 3G 2.5mm
2
L
2
L
1
N
380-415V 2N~ H05V2V2-F 4G 2.5mm
2
L
1
L
2
220-240V 2~ H05V2V2-F 3G 2.5mm
2
Before making the electrical connections, check that:
- the ground cable is 2 cm longer than the other cables;
- the system ratings meet the ratings indicated on the identifi cation plate fi xed on the lower part
of the worktop;
- the system is fi tted with effi
cient earthing compliant to the laws and regulations in force.
Earthing is obligatory by law.
If the appliance is not fi tted with a cable, use type:
“H05V2V2-F” for a power level of up to 6400 Watts, the cross-section of the cable should be at least
2.5 mm2, or 4 mm2 for greater power levels.
The appliance is designed for permanent connection to the electricity supply and should therefore
be fi tted with an omnipolar switch which has a minimum opening of 3 mm between contacts. The
switch should be suitable for the charge indicated on the appliance data plate and must conform
to all current legislation (the yellow/green earth wire must not be interrupted by the switch).
The omnipolar switch must be easy to reach once the installation process has been completed.
USE AND MAINTENANCE
Maintenance
Remove any residues of food and drops of grease from the cooking surface using the special scraper
supplied. (Fig.3)
Clean the heated area as thoroughly as possible using SIDOL, STAHLFIX or similar products and a
cloth/paper, then rinse with water and dry with a clean cloth.
Using the special scraper (optional) immediately remove any fragments of aluminium and plastic
material that have unintentionally melted on the heated cooking area or residues of sugar or food
with a high sugar content (Fig.3). In this way, any damage to the cooktop surface is prevented.
Fig. 2
Fig. 3
- 6 -