PROAPW300L- 300Mbps 2.4GHz In Wall Access Point
with RJ45 Port
PROAPW750L- 750Mbps 2.4 & 5GHz In Wall Access Point
with RJ45 Port
PROAPCEILING- 1200Mbps 2.4 & 5GHz Ceiling Access Point
Advanced Instructions
[email protected]
www.blake-uk.com
0114 223 5000
PD2011-8246-04
Manage setup menu:
Configure:- Allows you to save the configuration file to your computer.
Restore:- Restore the back of the configuration file (also useful for installing many
access points with the same configuration).
Reset Default:- Resets the access point back to the manufacturers default settings.
Telnet:- Allows access to the devices Telnet port (port 22).
Due to security risk we suggest this is turned off unless specifically needed.
Initially the AP is setup in Gateway mode. This is for ease of connection to your
device, for setup. In this mode the AP will allocate an IP, via its built in DCHP server,
to each device connected. This will mean that you will have a different IP range to
your usual network, on the devices connected to the AP and communication
between devices on each side of the AP is not possible. This may be an issue where
you have a printer connected to the usual network and a device connected via the
AP.
If this is an issue then please select the AP mode within the Wizard. The AP then
stops allocating IPs and leaves this job to the router, all devices will be on the same
network.
