BLADEZ XTR Street PB-SM1806, Руководство по продукту

Страница: 11 / 15

Page 11
CHARGING SYSTEM
This unit comes standard with a regulated 24V charger, this means that the power can
be left switched on for a long period of time without harm to the batteries.
NOTE: It is not advisable to leave your Powerboard plugged in for more than 24 hours.
ALWAYS CHARGE YOUR POWERBOARD PRIOR TO STORAGE
To re-charge your XTR-Street, simply connect the small round plug on the CHARGER
to CHARGING PLUG as described in GET STARTED Charging section.
Your Power Board is now fully charged and ready for use.
RECOMMENDED TOOLS
To adjust and service the Bladez XTR-Street Power Board you will need the following
tools:
Allen Keys: 3/4/5/6mm.
Wrenches: 10/13/14/17 mm Open and ring combination.
Large Adjustable Crescent Wrench
Philips Head Screwdriver
Oil, Grease or Lubricant (such as WD-40)
BRAKING SYSTEM
The XTR-Street uses a front wheel disc/calliper system activated by a hand lever (on
the left side of the handlebar). The brake is activated by squeezing the BRAKE LEVER
with your left hand. The XTR-Street is equipped with a controller that temporarily
disengages the power to the motor when the BRAKE LEVER is depressed.
Practice braking on a smooth, dry surface to get used to the feel of the braking system.
Braking distance is affected by wet conditions and loose and uneven riding surfaces.
Adjusting the Brakes
The Brakes on the XTR-Street should come fully
adjusted from the factory. However, it may be
necessary to adjust the brake from time to time.
To adjust the brakes:
1. Loosen the tension screw on the Brake Lever
by rotating it counter-clockwise until the
wheel spins freely, with some For further
adjustment:
Fig. 9