Page 11 of 15
on the folding handle while gently pushing down on the handlebars. BE CAREFUL
NOT TO HIT YOUR HEAD WITH THE HANDLEBAR. Use the locking hook, located
near the engine to secure the T-handle into place.
* NOTE: If the lever is pulled aggressively, the locking spring may become
stretched and then the steering will not lock into position, it is also advisable
to ensure scooter locks firmly, prior to riding.
You can now carry the MOBY X by the handlebar tube.
MAINTENANCE
RECOMMENDED TOOLS
To adjust and service the Bladez MOBY Power Board you will need the following
tools:
Allen Wrenches:
3 / 4 / 5 / 6mm.
Wrenches:
10 / 13 / 16 mm Open and ring combination.
Short reach Spark Plug Socket
Large Adjustable Crescent Wrench
Spark Plug Sockets
Philips Head Screwdrivers
Oil, Grease or Lubricant (such as WD-40)
CARBURETOR ADJUSTMENT
WARNING!
Never start the engine without the complete clutch cover assembled!
Otherwise the clutch can come loose and cause personal injuries.
In the Carburetor, fuel is mixed with air. When the engine is test run at
the factory, the Carburetor is basically adjusted. A further adjustment
may be required from time to time, depending on climate and altitude.
The Carburetor has only one possible adjustment:
T= idle speed adjustment screw
Idle Speed Adjustment (Fig. 9)
When the idle speed is adjusted properly, the engine will run smoothly,
without pressing the THROTTLE LEVER.
If adjustment is required:
1. Start the engine.
2. Using a long, Philips head screwdriver
gently close (clockwise) the T-screw
