BH North America Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
www.bladezfitness.com
18
MAINTENANCE
The running belt can shift to one side or simply ‘skid
over’ when running. To center the belt using the 6mm
Allen wrench, run the machine at 3mph for a few
minutes to determine which side the belt is drifting
towards; left or right.
If the belt is drifting left
i) Turn the treadmill off and unplug from the machine
ii) Tighten the left bolt a ¼ turn (clockwise)
iii) Loosen the right bolt a ¼ turn (counterclockwise)
iv) Run the belt at 3 mph again for a few minutes
If the belt continues to drift to the left, repeat
steps
If the belt is drifting right
i) Turn the treadmill off and unplug from the machine
ii) Tighten the right bolt a ¼ turn (clockwise)
iii) Loosen the left bolt a ¼ turn (counterclockwise)
iv) Run the belt at 3 mph again for a few minutes
If the belt continues to drift to the right, repeat
steps
Once the running belt has been adjusted closer to the
center, the treadmill can be powered on again.
It is recommended that the deck be lubricated
every 6~12 months according to the frequency
of usage.
WARNING!
Do not use cleaner under the running belt.
i) Use 6mm Allen wrench to loosen the bolts in
the end caps. Remove excessive accumulations
of dust, dirt, and other substances from running
deck. ONLY use a clean soft cloth.
ii) Gently pull up the side of the running belt, and
dispense a thin layer of the lubricant on deck,
and spread evenly. DO NOT over lubricate
iii) Center the belt (top of this page), and tighten
the end caps.
Check belt condition and adjust if necessary
referring to the steps above.
0.5~4.0 Miles / hr = lube every 1 year
4.0~7.0 Miles / hr = lube every 6 months
7.0~10.0 Miles / hr = lube every 3 months
Rear Roller Bolt
6 mm wrench
