Blade NANO QX 3d, Руководство пользователя

Страница: 6 / 13

10 11
EN EN
RTF
Transmitter Controls
F
G
H
E
A
D
C
B
Trigger
(bind switch)
Flight mode
switch
A B C D E F G H
Mode 2 Power
LED/rate
indicator
Aileron (Left/Right)
Elevator (Up/Down)
Eleva-
tor Trim
Aileron
Trim
ON/OFF
Switch
Rudder
Trim
Throttle
Trim
Rudder (Left/Right)
Throttle (Up/Down)
When pressed down, trim buttons make a sound that increases or decreases in pitch at each pressing. The middle or neutral trim position
is heard as a middle tone in the pitch range of the sounds. The end of the control range is sounded by a series of beeps.
Bind switch
Dual rate
switch
RTF
The Nano QX 3D RTF model comes with the Blade MLP6DSM transmitter.
This transmitter has a switch that lets the pilot change among 3 SAFE Technology flight modes.
IMPORTANT: Ensure the flight mode switch is in the desired position before flying.
• Beginner Mode (switch position 0).
Release the control sticks to neutral and the quadcopter will level itself.
• Intermediate Mode (switch position 1).
Release the control sticks to neutral and the quadcopter will level itself.
• Evo Mode (switch position 2). Only switch to this mode before takeoff. If switched to this mode in flight,
the quadcopter will only operate with switch position 1 options.
Control Sensitivity – Press down on the right stick: transmitter LED flashes for Low, LED solid for High (default)
Transmitter Trigger Options
• Beginner Mode (0) Flip– Press the trigger for a 360 degree flip, then move the aileron or elevator stick
fully in the desired flip direction.
• Intermediate Mode (1) Invert– Press the trigger once, then move the aileron or elevator stick fully in the
desired invert direction. The quadcopter responds to controls the same as when it is not inverted.
• Evo Mode (2) Throttle Cut– Press the trigger to cut throttle, stopping the motors for advanced 3D maneuvers.
SAFE Technology Flight Modes – RTF
0
1 2
Flight Mode Selection – BNF
If you purchased a BNF Nano QX 3D, the channel 5 switch on your transmitter will select flight modes. See the table on the following
page for specific setup information.