9
EN
DX7, DX9, DX18
In Channel Input Confi guration:
• Assign Channel 7 Input (AUX2) to R Knob.
• Assign AUX1 to A.
In Servo Setup:
• Set the AUX1 travel to the values below:
140%
120%
To change the gimbal angle, set switch A to position 0
and adjust the angle of the gimbal by rotating the
R Knob at any time.
ST10+ Personal Ground Station
The ST10+ requires no additional programming to
use the CGO3. Proceed to “Using the CGO3 With Your
ST10+ Personal Ground Station.”
Using the CGO3 With Your Spektrum Transmitter
1. Insert the micro SD card into the slot on the bottom
of the camera.
2. Place the quadcopter on a fl at and stable surface.
Ensure there are no obstructions in the path of the
CG03.
3. Switch on your transmitter.
4. Switch on your quadcopter.
After the CGO3 powers on, the LED will glow red for
approximately 40 seconds while the gimbal initializes.
When the LED changes to green the CGO3 is ready to
connect via WiFi.
See the “Using the CGO3 App” section for instructions
on how to connect your gimbal to your smart device
and for a description of the camera controls available.
The gimbal will now compensate for any roll, pitch
and yaw movements encountered by your quadcopter
in fl ight.
If desired, you may change the pitch angle of
the gimbal at any time using your programmed
transmitter controls.
