7
EN
®
Transmitter and Receiver Binding
If you purchased an RTF model, the transmitter is bound to the model at the factory.
To bind or re-bind your Nano CP X to your chosen transmitter, please follow the directions below:
Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique
Identifier) code of a single specific transmitter. You need to ‘bind’ your chosen
Spektrum
™
DSMX
®
technology
equipped aircraft transmitter to the receiver for proper operation.
NOTICE:
Use the Non-Computer Radio binding instructions if you are using a DX4e or DX5e transmitter
with the Nano CP X BNF.
Binding Procedure for Non-Computer Radio (DX4e, DX5e)
1. Disconnect the flight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the flight battery to the helicopter. The 3-in-1 Control unit LED flashes after 5 seconds.
4. Push the trainer switch or button while powering on the transmitter.
5. Move the rudder control stick to full left after the transmitter LED lights flash twice.
6. Release the trainer switch/button. Continue to hold the rudder control stick to
full left
until the blue LED
on the 3-in-1 control unit is solid.
7. Release the rudder control stick.
8. Push the trainer switch/button. The blue LED on the 3-in-1 control unit flashes to confirm the helicopter
is in non-computer mode.
9. Disconnect the flight battery and power the transmitter off.
Binding Procedure for Computer Radios:
1. Disconnect the flight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the flight battery to the helicopter. The 3-in-1 Control unit LED flashes after 5 seconds.
4. Push the bind switch/button while powering on the transmitter.
5. After 2–3 seconds, release the bind switch/button.
6. Move the rudder control stick to full right. Continue to hold the rudder control stick to
full right
until the
blue LED on the 3-in-1 control unit is solid.
7. Release the rudder control stick.
8. Disconnect the flight battery and power the transmitter off.
NOTICE:
The throttle will not arm if the transmitter’s throttle control is not put at the lowest position and the stunt
mode switch is not in the 0 position.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other
instructions. If needed, contact the appropriate Horizon Product Support office.
For a list of compatible
DSMX
transmitters, please visit www.bindnfly.com.
NOTICE:
If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer
transmitter mode; repeat binding procedure.
