5
4
Controls
1. CH 1 Gain
This gain control adjusts the amount of overdrive or distortion that
Channel 1 will deliver. As the Gain control is increased clockwise (CW)
the sound will become more overdriven moving through crunch tones
until at its maximum position, a full distorted crunch tone is arrived at.
2. CH 1 Level
This Level control sets the overall level or volume from Channel 1 of
the pedal. It should be used in conjunction with the Gain 1 control
to achieve the exact type of drive you require. Generally speaking at
lower Gain settings the Volume will be increased and at higher Gain
settings the Volume should be decreased.
3. CH 2 Gain
This Level control sets the overall level or volume from Channel 2 of
the pedal. It should be used in conjunction with the Gain 2 control
to achieve the exact type of drive you require. Generally speaking at
lower Gain settings the Volume will be increased and at higher Gain
settings the Volume should be decreased.
4. CH 2 Level
The Level control sets the overall level or volume for Channel 2.
5. Tone
The Tone control allows exact adjustment of the treble frequencies
within the sound, and is common to both channels. At low settings,
counter clockwise (CCW), the sound will be warm and darker in
character. As the control is increased clockwise (CW) the sound will
become brighter. At the maximum settings the tone will be aggressive
and cutting.
6. ISF
The ISF control works in conjunction with the Tone control, and is
common to both channels. It allows you to choose the exact tone
signature you prefer. Fully CCW is a more American characteristic
with a tight bottom end and more aggressive middle, and fully CW
is a British characteristic which is more ‘woody’ and less aggressive.
See illustration below.
We recommend that to start with the ISF is set to half way and the
Tone control set to taste. Then try gradually adjusting the ISF CW and
CCW until you find the sound you prefer.
7. CH 1 On/Off Switch
Press this switch to turn Channel 1 on or off. Note, if Channel 2 is
already active, pressing this switch will change to Channel 1.
8. CH 2 On/Off Switch
Press this switch to turn Channel 2 on or off. Note, if Channel 1 is
already active, pressing this switch will change to Channel 2.
9. CH 1 On/Off LED
When the green LED is on Channel 1 is active. When the LED is not
on, Channel 1 is off.
10. CH 2 On/Off LED
When the red LED is on Channel 2 is active. When the LED is not on,
Channel 2 is off.
11. Input
Plug your guitar in here. Always use a good quality screened guitar
lead. To maximise battery life unplug your cable from the pedal when
not in use.
12. Output
This output is for connection to the input of your amplifier or into other
pedals or effects. For best noise performance we recommend you
place the LT DRIVE pedal first in the effects chain. Always use a good
quality screened guitar lead.
10
0
ISF
Frequency
Amplitude USA
UK
USA
UK
English
English
