English
21
Technical Specification
ID:60TVP
Power:
60 Watts
Weight (kg):
18
Dimensions (mm):
584(W
x 485(H
x 250(D
Footswitch (not supplied):
F
:
-4 latching footswitch, F
:
-10 footcontroller,
MIDI footcontroller
ID:60TVP-H
Power:
60 Watts
Weight (kg):
10.8
Dimensions (mm):
584(W
x 236(H
x 225(D
Footswitch (not supplied):
F
:
-4 latching footswitch, F
:
-10 footcontroller,
MIDI footcontroller
ID:260TVP
Power:
2 x 60 Watts (
:
tereo
Weight (kg):
24.2
Dimensions (mm):
686(W
x 510(H
x 250(D
Footswitch (not supplied):
F
:
-4 latching footswitch, F
:
-10 footcontroller,
MIDI footcontroller
ID:100TVP
Power:
100 Watts
Weight (kg):
12.8
Dimensions (mm):
686(W
x 246(H
x 225 (D
Footswitch (not supplied):
F
:
-4 latching footswitch, F
:
-10 footcontroller,
MIDI footcontroller
USB Audio
:
tandard audio drivers are used to connect the amplifier to a PC or Mac, no specific
drivers are required.
The amplifier will appear as an audio capture device within recording software.
The output of the audio over U
:)
can be changed via the
)
lackstar Insider software,
and can be one of the following
!
:
peaker emulated stereo effected audio channels
2 x mono audio channels
-
3
eft – effected amplifier signal
- Right – unprocessed guitar signal
Re-amping Mode
Re-amping
The amplifier can be switched into Re-amping Mode via
)
lackstar Insider software.
This is a non-storable setting and will be switched off either when the U
:)
cable is
removed, or when the amplifier power is switched off.
When activated, Re-amping Mode allows the amplifier to accept a pre-recorded, dry
guitar signal via U
:)
and return a fully processed audio signal. This return signal can
then be captured using recording software on the connected PC or Mac.
Firmware Update
Firmware updates are initiated via
)
lackstar Insider software. A new version of the
)
lackstar Insider software will be released whenever an update is available. Each
update will take approximately 60-120 seconds.
When the amplifier is connected (via U
:)
to a version of the
)
lackstar Insider
software containing newer firmware, a message will be displayed, prompting you to
install the latest files. Whilst updating, the amplifier controls will be unresponsive. The
Tap
3
ED flashes to indicate data activity during the update process.
The amplifier power should not be switched off during a firmware update. If the
amplifier is switched off during an update, the controls will be unresponsive after the
power is reapplied and the amplifier will produce no sound. The Tap
3
ED will flash
to indicate that the amplifier contains no valid firmware.
The amplifier must be connected to the
)
lackstar Insider software to reinstall valid
firmware. The update process will start automatically if the
)
lackstar Insider software
detects that the amplifier is in this state.
English
20
