11
STARTING AND STOPPING YOUR INFLATOR
Pic. 4
NOTE: Always ensure that you plug your infl ator into a
standard 240V AC power point. Never use an extension cord
as this can lead to a voltage drop which may cause power
loss and over heating. Use a longer air hose if you need to
get closer to your work area.
Always start and stop the infl ator using the
ON/OFF button on the Pressure Switch (Pic. 1 Item 1 and 2 as
well as Pic. 5). Damage caused by not using this button will not
be covered by warranty.
To turn your infl ator ON;
Lift up the red ON / OFF button on top of the pressure switch
To turn your infl ator OFF;
Push down the red ON / OFF button on top of the pressure
switch
RUNNING IN YOUR NEW INFLATOR
Your infl ator does not require running in. Before use ensure
you have read and understood these instructions.
Before use ensure this infl ator is fully assembled as per
page 10.
Positioning your new infl ator
Choose a location away from your work area and near to a mains
power point.
NOTE: 1. Never use an extension lead. Always use a longer
air
hose
2. Always position infl ator on level ground
3. Always position infl ator away from work area so
that the infl ator does not get covered in dust or paint -
use a longer air hose to ensure infl ator is in clean air
PIC. 5
Push button
down for off
Lift button
up for on
