Operation:
Setup:
1.
Ensure that the unit is connected to the appropriate power source using the provided AC
power plug.
2.
Ensure that the master and all gain controls are turned to the “0” position before connecting
any audio source.
3.
Place the speaker in a location that is away from any direct heat source, moisture, or extreme
humidity.
Playback:
*Use the Mode select button (5.) to choose between SD Card, USB, or Bluetooth*
1.
Using a USB storage device: The player can accept thumb drives and storage devices in USB 2.0
or less format. Files can be played back formatted as MP3 only. The USB connection can read
devices up to 4GB.
2.
Using a SD card: The player can accept thumb drives and storage devices in USB 2.0 or less
format. Files can be played back formatted as MP3 only. The SD Card input can read devices up
to 4GB.
3.
Using Bluetooth: Ensure that your audio source has bluetooth enabled, next turn your speaker
on and the bluetooth module will attempt to connect. You will hear a beep and a message that
confirms connectivity. Once connected please select the model form your Bluetooth device for
connection.
4.
Using Line in: Ensure that your line In RCA connections is securely connected to the speaker
and audio source before powering on this unit. Ensure that the line in gain control (22.) is in the
“0” position. Once connected set the gain control (22.) to #5. If your music source has a volume
control ensure that the volume is set to 75%. Begin playing music and adjust the master
volume to your desired level.
5.
Using Microphones: Ensure that the Microphone gain control (13. / 18.)is set to “0”. Connect
your microphone to the XLR, or ¼” Jacks located on inputs one and two.(10.11.15.16.) Ensure
that your microphone is turned on. Adjust the Gain (13./18.) to the #5 position and adjust
master volume control (26.) to desired volume.
Connecting to other speakers and amplifiers:
To connect to other speakers or external audio amplifiers please use the RCA Stereo Outputs
(20). Your Master unit should be connected to Line out (20.) Your slave unit should be
connected to your line “input”.