OPERATION
1. Determine the location of the two engine support bolts
on your vehicle. Then place the transverse support
bar directly over these two bolts.
2. Adjust the boom extension (#2) to ensure that both
legs (#13 & 14) are sitting inside the fender of the
engine compartment.
If the inside fender lips are more than 61"
apart, the Engine Transverse Support Bar must
not be used. Do not exceed the designated marking
(61"). Over-extending could cause the Engine Transverse
Support Bar to collapse, resulting in personal injury or
property damage.
3. Adjust to ensure the support arm (#10) is in correct
position. The rubber tip of the adjustable leg (#6)
should be on a flat, reinforced surface capable of
supporting the weight of engine. Tighten both wing
nuts (#4 & 8) to secure the adjustable leg (#6) and
support arm (#10).
4
!
4. Lower the threaded hooks (#3) to appropriate
position. Ensure that the hooks are directly over the
engine support bolts or brackets; therefore the engine
does not swing when vehicle is disassembled.
5. Attach
the looped ends of the two 1/8" braided steel
cables (#12) to the engine support bolts on the
engine and loop middle of braided cables over hooks.
If the engine being supported is equipped with engine
lift brackets, hook the hooks (#3) directly into engine
lift brackets for extra protection.
Note:
Use only fasteners rated Grade 5 or higher as
engine support bolts.
6. Tighten the barrel hex nuts (#7) on both hooks until
cables are snug or hex nuts are tight against support
bar.
7. Double check that engine is properly supported
before disassemble the vehicle.
MAINTENANCE
Periodically inspect the Engine Transverse Support Bar.
Ensure all parts move freely. To help prevent rust, wipe
clean and/or blow dry after each use. Store the Engine
Transverse Support Bar in a clean, dry area.
•
Study, understand, and follow
all instructions
provided before use.
•
Do not
exceed rated capacity.
•
Do not
exceed maximum width.
• Never crawl under the suspended load for any
reason.
• Ensure that the engine is supported securely
before repairing.
• Do not use this device for any purpose other than
that for which it is intended.
• Use
only
those chains, slings, accessories and
adapters provided by the manufacturer.
• No alterations shall be made to this product.
•
Failure
to heed these markings may
result
in
personal injury and/or property damage.
!
WARNING
REPLACEMENT PARTS
(page 5)
Not all components of the jack are replacement items,
but are illustrated as a convenient reference of location
and position in the assembly sequence. When ordering
parts, give Model number, serial number and parts
description. Call or write for current pricing:
SFA Companies, 10939 N. Pomona Ave. Kansas City,
MO 64153, U.S.A.
Tel: (816) 891-6390 Fax: (816) 891-6599 E-Mail:
