E Z - 1 Q U A D R I B E N T A S S E M B L Y A N D U S E R G U I D E
7
5) Bring the
left bike
parallel to the right bike and
connect at the
front beam
and the
lower beam
.
Tighten the bolts enough to hold in place.
6) Find the
rear beam
1 x 1 x 20” square aluminum
tube. Attach it to the
angle brackets
at both rear
axles. Install the two outboard ¼” x 1¾” bolts
(tighten enough to hold in place).
CARGO PLATFORM INSTALLATION
7) Find the
cargo platform
(18 x 30” aluminum
sheet). With the three flanges up and the flange
down at the rear, slide the platform over the
rear
beam
forward to the
lower beam
. Install two ¼” x
2” bolts through the
platform/lower beam
at the
front and two ¼” x 1¾” bolts through the
platform/rear beam
. Rear beam should still be
loosely bolted. If all four bolts can not be installed, as
a last resort, you can ‘chase’ the hole with a ¼” drill.
8) Find the
cargo platform support
(8” x 18”
aluminum sheet). Place the
support
on the
platform
, bent flange down, and attach with three
¼” x ¾” bolts. Tighten when all 3 bolts are in place.
9) Find the
top beam
(1” x 1” x 29 ½” square
aluminum tube). With the rubber pads to the rear,
(to go against the seat post) attach it to the
support
with three ¼” x 1-½” bolts. Tighten bolts. (maybe
already assembled)
Figure 9
10) Find the two
top brackets
(3 ¼” x 1” formed
aluminum). Place behind the seat tube and attach to
the
top beam
with two ¼” bolts.
Figure 10
Figure 6
www.blackbirdbikes.com