19
High Performance IR CCTV Bullet Camera User Manual
SECTION 3: SOFTWARE SETUP
AREA SELECT
: You can configure up to four motion detect areas on the image. Each motion detect areas can be
individually positioned and sized:
—
Move the cursor to AREA SELECT, then rock the joystick right or left to select AREA1, AREA2, AREA3, or AREA4.
—
Move the cursor to AREA DISPLAY, then rock the joystick right or left to select ON to configure that area, or OFF to
disable that area, then push the joystick in to confirm your selection. If ON is selected, the POSITION display will open:
—
In the POSITION display, rock the joystick left, right, up and/or down to move the block (detection area) to the
region of the display you want to monitor, then press the joystick in to select that position.
—
In the SIZE display, rock the joystick right or left to expand or contract the area horizontally. Rock the joystick
down or up to expand or contract the area vertically. Press the joystick in twice to return to the MOTION
submenu.
—
Move the cursor to SENSITIVITY, then rock the joystick left or right to adjust the motion detection sensitivity for
objects in you want the camera to detect in that area.
Repeat this procedure to configure or disable the other motion detection zones.
MOTION VIEW
: This feature is used to highlight objects found moving in motion detection areas.
—
OFF
. When set to OFF and motion is detected in any motion detection area, the message “
MOTION
” appears on
the camera image.
—
ON
: When motion is detected, objects moving in the motion detection areas are highlighted, and the message
“
MOTION
” appears on the camera image.
RETURN
: On the D-EFFECT menu, select RET to return to the SPECIAL menu, or END to close the SETUP menu.
PRIVACY
: The PRIVACY feature allows you to block areas of the image from being displayed. Set PRIVACY to ON to open the
PRIVACY sub-menu.
