◼
On your sound system, mute your monitors and then using balanced XLR cables, connect your
B172A to your mixing bus or patch bay. If you are using two B172As in parallel (or stereo), connect
the RCA’s between the two units on both channels.
◼
Set all controls to full counter-clockwise position, and all pushbuttons deselected or in the off
position. Set the Bypass switches to the bypass position, bypassing the unit, and apply power.
◼
Unmute the monitors, and verify that signal is passing to and from the unit.
SEVENTEEN
◼
Set the INPUT, OUTPUT, ATTACK and RELEASE controls to about 12 o’clock, select RATIO 4,
and switch the bypass switch away from bypass. Increase the INPUT until the meter is deflecting a
few dB. Again, verify signal is passing through the unit.
2A
◼
Set the INPUT and OUTPUT controls to about 12 o'clock and switch the bypass switch away
from bypass. Increase the INPUT until the meter is deflecting a few dB. Again, verify signal is
passing through the unit.
IMPORTANT NOTE ON ROUTING AND SETUP: The routing switch switches both the input jack
and the output jack of the unit when in A-B/B-A modes. This means that in A-B mode, the input
signal goes into A's input and B's output and vice versa in B-A mode. Because of this, BOTH chan-
nels need and input signal and both channels need an output signal so that both routing options
work properly. If one channel is bypassed, the signal has no way to route from one channel's input
to the others output, this will cause the unit to be silent and not pass signal.
Your B172A is now ready for use!
QUICK START GUIDE
4
PACKAGE CONTENTS
B172A |
User Manual
• B172A
• IEC cable
• 4x desktop feet & screws
Содержание B172A
Страница 1: ...B172A User Manual...
