26
MESSERSCHMITT BF-109E -
Item code:BH109
.
Instruction Manual
1
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
1
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
Do not permanently secure the receiver and
battery until after balancing the model.
1
3. Position the battery pack and receiver
behind the fuel tank. Use two tie wraps to hold
the battery and receiver securely in place as
pictures below
1
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
1
1.Locate the aluminium wing dihedral
brace.
25mm
19 mm
632 mm
827 mm
*** Test fit the aluminium tube dihedral brace
into each wing haft. The brace should slide in
easily. If not, use 220 grit sand around the
edges and ends of the brace until it fits prop-
erly.
1
2. Attach the aluminium tube into the
fuselage.
INSTALLING THE RECEIVER AND BATTERY.
Switch of
Receiver
Tie wrap.
Battery
receiver
Battery of
engine
Receiver.
WING ATTACHMENT.
