19
EXTRA 300S
- Item code:
BH130 INSTRUCTION MANUAL.
1. Set the tail wheel assembly in place
on the plywood plate. The pivot point of the
tail wheel wire should be even with the rud-
der hinge line and the tail wheel bracket should
be centered on the plywood plate.
2. Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
Rudder push-pull system install as sams
as picture below
M3 clevis ( 4pcs for push - pull system ).
M3 lock nut.
RUDDER CABLE PUSHROD INSTALLA-
TION.
Rudder cable.
Bottom side.
Rudder cable.
E l e v a t o r
Pushrod.
Cut off the excess
cable wire
MOUNTING THE TAIL WHEEL
BRACKET.
3x12mm
3x15mm
Drill a
hole 3mm
