EP-TRAINER.
10
Mark line
Top side
Remove covering
.
Top side.
Top side.
Bottom side.
2) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a traingle and
extend this mark, from back to front, across
the top of the stabilizer. Also extend this mark
down the back of the trailing edge of the stabi-
lizer .
3. Slide the stabilizer into place in the precut
slot in the rear of the fuselage.The stabilizer
should be pushed firmly against the front of
the slot.
4. With the stabilizer held firmly in place,
use a pen and draw lines onto the stabilizer
where it and the fuselage sides meet. Do this
on both the right and left sides and top and
bottom of the stabilizer.
5. Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
When cutting through the covering to remove
it, cut with only enough pressure to only cut
through the covering it’s self. Cutting into the
balsa structure may weaken it. This could lead
to possible failure during flight
Bottom side.
Bottom side
Mark line
Center line.
