Black Horse Model Corsair BH64, Инструкция по эксплуатации, Страница: 37 / 48

INSTRUCTION MANUAL F4U CORSAIR Item code: BH64
37
INSTALLING THE SWITCH
1) The switch should be mounted on the fuselage
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face plate
of the switch cut out and locate the mounting holes.
2) Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
3) Secure the switch in place using the two
machine screws provided with the radio system.
1) Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron extension
into the receiver to make plugging in the aileron servo
lead easier when you are installing the wing. Plug the
battery pack lead into the switch.
2)
Wrap the receiver and battery pack in the protective
foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
Do not permanently secure the receiver and
battery until after balancing the model.
INSTALLING THE SWITCH, RECEIVER AND BATTERY
INSTALLING COCKPIT FUSELAGE
Position the canopy so the rear frame on the
canopy is aligned with the rear edge of the cockpit
opening. Use canopy glue to secure the canopy to
the canopy hatch. Use low-tack tape to hold the
canopy in position until the glue fully cures. Wrap
the tape completely around the canopy hatch.
Fuselage top side
Must be purchased
separately!
Receiver
Switch ON
OFF