CAP 232-EP.
INSTRUCTION MANUAL.
16
1) Using a modeling knife, remove the
covering from over the two main gear mount-
ing slots located in the bottom of the fuselage.
2) Using the two landing gear straps as a
guide, mark the locations of the four mount-
ing screws onto the fuselage surface.
3) The landing gear wire is held in place
using two nylon landing gear straps and four
wood screws.
MAIN GEAR INSTALLATION.
wood collars
Secure
Remark
Cut
Rudder pushrod
Remove covering
Remove covering into place in the pre-cut
slot in the right side of rudder as picture be-
low.
C/A glue
Rudder cotrol horn
Rudder pushrod
Elevator pushrod
