JU87 - STUKA
.
Item code: BH80A.
Instruction Manual
4
1. INSTALLING THE AILERON SERVOS
I. AILERON
Drill a hole
1.5mm
Servo tray
Remove the covering
See pictures below:
Bottom side.
Aileron
Flap
Flap
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
REPLACEMENT SMALL PARTS
1. Oleo Strut
2. Wheels.
3. Plastic fairing for landing gear.
4. Wheel pants.
5. Plastic top wing.
6. Horizontal stabilizer struts.
7. Spinner
8. Tail gear set.
9. Fuel tank.
9a. Clunk.
9b. Stopper (three line).
10. Wood - motor mount.
11. Plastic - engine mount.
11
3x12mm
2x10mm
4x30mm
4x30mm
4x70mm
3x12mm
6
9
3x15mm
5x15mm
4x15 mm
1
2
3
4
8
3 x 12mm
5
10
7
9a
9b
M2
