5
YAK 54 -
ITEM CODE: BH48
.
Instruction Manual
Temporary pin to
keep hinge centered.
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Cut the covering
away from the slot.
2. Using a modeling knife, remove the cov-
ering at possition show below.
Bottom of wing.
Remove the
covering.
3. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out,
remove the masking tape and the servo lead
from the thread.
4) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
Thread.
Electric
wire.
1. Install the rubber grommets and brass
eyelets onto the aileron servo.
INSTALLING THE AILERON SERVOS.
Bottom of wing.
Aileron
