P47-THUNDERBOLT
.
Item code: BH36-B.
Instruction Manual
10
Pushrod wire
VI. COWLINg
1)
Slide the fiberglass cowl over the engine and
line up the back edge of the cowl with the marks you
made on the fuselage.
2)
While keeping the back edge of the cowl flush
with the marks, align the front of the cowl with the
crankshaft of the engine. The front of the cowl should
be positioned so the crankshaft is in
nearly
the middle
Drill four 2.5mm pilot holes through both the cowl and
the side edges of the firewall. Using a 3mm drill bit,
enlarge the four holes in the cowling.
Cowl area cutout
for muffler
Cowl area cutout
for engine head.
1)
Elevator install as same as the way of aileron
.
Please see pictures below.
VII. INSTALLINg HORIzONTAL
STABILIzER
2)
Using a modeling knife, carefully remove the film
covering from the tail slots at the rear of the fuselage.
Make sure that you do not remove any wood from the
slots as this will affect the alignment of the tail.
Pushrod wire
Throttle servo
Connector
Servo arm
Secure
Cut
Throttle pushrod
3x12mm
Secure
Drill a hole
2.5mm
of the cowl opening. Hold the cowl firmly in place using
pieces of masking tape.
3)
Slide the cowl back over the engine and secure
it in place using four wood screws. See picture below.
4)
Install the muffler and muffler extension onto
the engine and make the cutout in the cowl for muffler
clearance. Connect the fuel and pressure lines to the
carburetor, muffler and fuel filler valve.
