Black Horse Model BH178, Инструкция по эксплуатации

Страница: 46 / 64

FOCKE WULF Item code: BH178 Instruction Manual
INSTALLING THE RECEIVER AND BATTERY INSTALLING THE SWITCH
1. Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron extension
into the receiver to make plugging in the aileron
servo lead easier when you are installing the wing.
Plug the battery pack lead into the switch.
1. The switch should be mounted on the fuselage
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face plate
of the switch cut out and locate the mounting holes.
2. Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
3. Secure the switch in place using the two machine
screws provided with the radio system.
2. Wrap the receiver and battery pack in the protective
foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
Do not permanently secure the receiver and battery
until after balancing the model.
!
46
Fuselage Top Side
Zip tie
Zip tie
Valve control servo
Air tank
Air tank
- - - - - - - - - 1
- - - - - - - - - 2
3 x 12mm TP Screw