Black Horse Model BH169, Инструкция по эксплуатации

Страница: 13 / 33

Instruction manual JUNKERS JU87- B2 STUKA Item code: BH169
To carburetor
fuel inlet
(see front view of fuel tank). Insert and tighten the screw.
Be sure to equip
air vent pipe.
Tubing for
re-fuelling
Not included.
Tygon tubing (Gas). And
silicone tubing (Methanol).
5mm
INSTALLING THE FUEL TANK.
1) The stopper has been pre-assembled at the
factory.
2) Using a modeling knife, cut one length of silicon
fuel line (the length of silicon fuel line is calculated by
how the weighted clunk should rest about 8mm away
from the rear of the tank and move freely inside the
tank). Connect one end of the line to the weighted
clunk and the other end to the nylon pick up tube in
the stopper.
3) Carefully bend the second nylon tube up at a 45
degree angle (using a cigarette lighter). This tube will
be the vent tube to the muffler.
4) Carefully bend the third nylon tube down at a 45
degree angle (using a cigarette lighter). This tube
will be vent tube to the fueling valve.
When the stopper assembly is installed in the
tank, the top of the vent tube should rest just below
the top surface of the tank. It should not touch the top
of the tank.
5) Test fit the stopper assembly into the tank. It may
be necessary to remove some of the flashing around
the tank opening using a modeling knife. If flashing is
present, make sure none of it falls into the tank.
6) When satisfied with the alignment of the stopper
assembly tighten the 3mm x 20mm machine screw
until the rubber stopper expands and seals the tank
opening. Do not over tighten the assembly as this
could cause the tank to split.
7) Using a modeling knife, cut 3 lengths of fuel line.
Connect 2 lines to the 2 vent tubes and 1 line to the fuel
pickup tube in the stopper.
8) Feed three lines through the fuel tank compartment
and through the pre-drilled hole in the firewall. Pull the
lines out from behind the engine, while guiding the fuel
tank into place. Push the fuel tank as far forward as
possible, the front of the tank should just about touch
the back of the firewall.
Blow through one of the lines to ensure the fuel lines
have not become kinked inside the fuel tank
compartment. Air should flow through easily.
Do not secure the tank into place permanently until
after balancing the airplane. You may need to remove
the tank to mount the battery in the fuel tank
compartment.
9) Secure the fuel tank.
Silicone tube
Foam ring
Fuel tank
INSTALLING THE ENGINE, FUEL TANK
13